Gas log installation sized to your Falcon Trace fireplace
Gas log installation from a local family team that answers the phone, inspects for free and stands behind the work with a satisfaction guarantee.
- Licensed & insured
- Locally run
- Family owned and operated
- Same-day service available
Your free gas log inspection in Falcon Trace looks at
Our gas log pros check these points in person in Falcon Trace, then write every one into the proposal.
- Damper clamp or permanent stop for a vented set
- Gas type on the rating plate against your supply
- Sand or vermiculite matched to the gas type
- Noncombustible facing and mantel clearance
Our approach to gas logs in Falcon Trace
What our gas log specialists explain to homeowners in Falcon Trace before a set is ordered.
An ash lip or recess at the firebox front
Some fireboxes have a raised lip or a dropped recess just inside the opening. One log set maker does not allow its burner in a fireplace where that lip or recess is deeper than 3/4 inch.
The same manual measures the firebox depth from inside the lip, so a lip can make a deep-looking firebox too shallow on paper. Our installers measure the lip and the true depth before choosing a burner size.
Glass doors on a fireplace with gas logs
Glass doors change how air reaches a burner. One log set maker wants the doors wide open the whole time the burner is lit, and where a door frame shuts off air to the fireplace floor, it asks for ventilation slots in the frame just above the floor.
The same manual says the opening with the doors fully open must still meet the minimum front width and height for the burner. Our crew checks the frame, the slots and the opening size before recommending a set.
Where local rules limit vent-free sets
Vent-free sets are not allowed everywhere. One manual notes that state and local codes in some areas prohibit the use of vent-free heaters, and that some codes allow operation only in a vented configuration.
Before a vent-free set is recommended for your address, our crew confirms what applies there and whether your homeowners association or building has rules of its own. When the answer is unclear, the estimate says so and offers a vented set instead.
Dual-fuel vent-free sets
Some vent-free sets ship ready for one gas and can be changed to the other. One manual describes a set shipped for propane that a qualified installer can convert to natural gas by following its instructions and markings, with no other field conversion allowed.
Our crew confirms which gas your home uses before installation and completes any conversion the manual allows, then marks the set so the next technician knows how it is configured.
What the written gas log estimate lists
Our estimate names the log set by maker and model, the burner size, the damper clamp or stop, the media and embers and the controls. Repairs, removal of the old set and any gas piping by others each get their own line.
What you approve is what you pay, unless you agree to extra work. No fees hide in the fine print, and when you book within 72 hours after the inspection, 10% off is printed on it.
- Log set, burner and controls
- Damper clamp or permanent stop
- Repairs the fireplace needs first
- Gas piping by others, if any
Other work in Falcon Trace
-
-
-
-
-
Questions Falcon Trace homeowners ask before gas logs
Straight talk on log sets from our specialists in Falcon Trace, and no pressure to book.
Is the gas line part of the job?
New gas piping is separate work for a qualified gas contractor, and it appears as its own line on the estimate. Before that, our crew checks what the log set manual asks of the supply, such as the minimum pipe size and inlet pressure.
How big a log set will fit my fireplace in Falcon Trace?
It depends on the firebox. We measure the front width, the rear width, the depth and the height, and compare them with the set's table. One maker's smallest burner needs a firebox 26 inches wide at the front and 15 inches deep.
Request your free estimate
Share the job details and arrange a free inspection with our local team.
- Free inspection
- No hidden fees
- Family owned and operated
Need an answer now? Call (352) 675-6376
Your request is received
Thank you. We will contact you to discuss the job and confirm an appointment.