Chimney flashing repair for Lake Pickett homes
One local family team inspects, estimates and repairs chimney flashing in Lake Pickett, and explains every step along the way.
- Licensed & insured
- Locally run
- Family owned and operated
- Same-day service available
Your free flashing inspection in Lake Pickett looks at
Checked and noted by our local family team in Lake Pickett, then explained in plain language.
- Apron flashing across the downhill face
- Old tar, caulk and patch metal to remove
- Attic side of the chimney, where reachable
- Exposed fasteners and old mounting holes
How we handle chimney flashing repair in Lake Pickett
Three parts of the job our flashing specialists explain to homeowners in Lake Pickett before any metal is ordered.
Where sealant does belong in a flashing job
Sealant has a real role in chimney flashing. It closes the joint where counter flashing enters the masonry, seals seams between pieces and fills the hidden side of bends. What it should not do is stand in for missing metal or bridge an open gap by itself.
The product matters too. A roof sealant has to suit the metal, the masonry and the heat and sunlight it will face. We name the product in your written scope and apply it only where the flashing design calls for it, so a later roofer or chimney crew can see exactly what was used and where.
Solar panels close to the chimney
Solar arrays sometimes sit tight against a chimney, which can limit the room needed to lift roofing and set new flashing. Panels also change where water runs on the roof, especially where rails or conduit cross near the chimney.
We check the clearance around the chimney before quoting. If panels need to be moved or shielded during the flashing work, we tell you up front so the solar installer can be booked. The repair is then planned around that access rather than squeezed in.
A safe way to check your flashing from the yard
A pair of binoculars from the yard or an upstairs window shows a lot. Look for gaps between metal and masonry, rust streaks below the chimney, metal that has lifted and dark patches of tar or sealant around the base.
Write down what you see and on which side. That is useful information when you call, and it helps us bring the right materials to the first visit. We handle the climbing so you never need to.
Patch metal slipped over old flashing
A common quick fix is a new piece of metal slipped over or under the old flashing and sealed at the edges. It can stop a drip for a while, but it adds another set of seams and hides what is happening underneath.
We remove patch pieces during a full repair to see the original metal and the roof beneath. If a patch has actually been working, we tell you, and we can discuss whether a smaller repair makes sense.
Other work in Lake Pickett
-
-
-
-
-
Learn more about chimney flashing repairLake Pickett services
What people in Lake Pickett ask about chimney flashing
Answers from our specialists in Lake Pickett, with no sales pressure.
Does my chimney need a cricket?
The Florida Building Code, Residential, calls for a cricket on the ridge side of a chimney more than 30 inches wide. We measure your chimney and tell you whether the rule applies. Cricket work is quoted on its own line.
Do you stand behind the flashing work?
Yes. Flashing we install comes with our workmanship warranty and our 100% satisfaction guarantee, and if anything is off, our crew returns to correct it.
Request your free estimate
Share the job details and arrange a free inspection with our local team.
- Free inspection
- No hidden fees
- Family owned and operated
Need an answer now? Call (352) 675-6376
Your request is received
Thank you. We will contact you to discuss the job and confirm an appointment.