Repointing chimney brick without harming it in Lockwood
Chimney repointing in Lockwood, priced upfront with no hidden fees and backed by a 100% satisfaction guarantee.
- Licensed & insured
- Locally run
- Family owned and operated
- Same-day service available
Your tuckpointing estimate in Lockwood, point by point
These checks keep repointing in Lockwood from covering up a problem it cannot fix.
- Joints to repoint, mapped face by face
- Hand tools for head joints and soft brick
- Brush cleanup at the joint edges
- Areas left alone and the reason
Tuckpointing details that matter for Lockwood homes
Homeowners in Lockwood ask about points like these on almost every chimney we repoint.
Liner joints inside the flue
Clay flue tiles inside a chimney are set in refractory mortar, and those joints can open or erode over time. They sit inside the chimney, out of reach of exterior repointing.
When our crew inspects your Lockwood chimney for tuckpointing, we look down the flue from the top where access allows. If liner joints need attention, that is flue repair, quoted as a separate job, so you know the exterior repointing and the flue are two different pieces of work. Knowing that up front avoids the idea that exterior joint work has sealed the flue.
The mortar types behind the letters
ASTM C270 groups masonry mortars into Types M, S, N and O, from strongest to weakest, and the Brick Industry Association's Technical Note 8B explains how to choose among them. The letters are shorthand for proportions of cement, lime and sand.
When our estimate for your Lockwood chimney names a mortar type, this is the system it refers to. Knowing the type helps any future mason match the joints, and it lets you compare our proposal with another quote on the same terms. Technical Note 46 recommends Types N, O or K for repointing, which leaves the stronger Types M and S out of it.
A uniform depth across the joints
Technical Note 46 describes raking deteriorated mortar to a uniform depth. When some joints are raked deep and others barely touched, the new mortar varies in thickness from joint to joint, which makes an even bond and an even finish harder to achieve.
Our masons work each area of your Lockwood chimney to a consistent depth, head joints as well as bed joints. It is slower than chasing only the worst spots, and it is what gives the new joints an even bond and an even look. An even depth also makes the finished joints look consistent from the street.
Other work in Lockwood
-
-
-
-
Before your chimney repointing in Lockwood
Our family-owned team in Lockwood answers what people ask about tuckpointing.
Should I seal the chimney after repointing?
Not right away. Industry guidance advises waiting several months after repairs before deciding on a water repellent, since coatings can trap moisture. We can talk through the options once the mortar has cured.
What if my chimney is stucco or stone?
Stucco has no exposed joints to repoint, and stone joints need a different approach. We tell you at the inspection and point you to the service that suits your chimney.
Request your free estimate
Share the job details and arrange a free inspection with our local team.
- Free inspection
- No hidden fees
- Family owned and operated
Need an answer now? Call (352) 675-6376
Your request is received
Thank you. We will contact you to discuss the job and confirm an appointment.