Chimney repair with a free inspection in Moss Park

Worn mortar joints let water in

Mortar joints are often where water gets into a brick chimney. BIA maintenance guidance says moisture may penetrate brick masonry through unbonded, cracked or deteriorated joints, and it lists the conditions that call for repointing.

Light scraping with a metal tool and a close look show where mortar has gone soft. The same guidance calls repointing, sometimes known as tuckpointing, one of the most effective ways to reduce moisture penetration, and it advises repointing all the joints in the affected wall area, since it can be hard to tell which joints are letting water through.

Worn joints on homes in Moss Park are routed to our chimney tuckpointing service. The estimate marks each wall area to be repointed.

• Mortar eroded back from the brick face
• Mortar that crumbles or has voids
• Hairline cracks in the mortar
• Cracks between the brick and the mortar

Weep holes and through-flashing at the base of veneer

At the bottom of a brick or stone veneer chimney there should be flashing under the first course, with small openings called weep holes just above it. Together they give water that gets behind the veneer a way out. The Florida Building Code requires both where masonry veneers a frame chimney.

Weeps are easy to spoil by accident. They get filled with caulk by someone who takes them for gaps, painted over or clogged from inside by mortar droppings. Brick Industry Association guidance treats flashing and weeps as essential details that no coating replaces, and it describes clearing clogged weeps with a thin dowel or stiff wire without damaging the flashing behind them.

Any water complaint on a veneer chimney includes a look at its base for the points below. Reopening blocked weeps, or adding them where they were left out, is priced as a separate line from the repair higher up.

• A row of open weeps just above the base flashing
• Flashing visible at the bottom course
• No caulk, paint or mortar plugging the openings

Chimney repairs on a rental property

On a rental, the person who notices a chimney problem is usually the tenant, and the person who pays for it is the owner. Small problems wait too long in that gap. A tenant may keep using a fireplace with a stuck damper or a damp firebox because nobody said not to.

Until the chimney has been looked at, the simplest protection is telling the tenant in writing not to use the fireplace. It also keeps a small fault from getting worse before anyone has looked at it.

The written estimate goes to the owner, with each repair on its own line so it can be approved, phased or passed to a property manager. For rental owners in Moss Park, no work starts until the person paying for it approves it. The visit itself goes smoother with the practical side settled first.

• Notice to the tenant before the visit
• Access to the attic if the chimney runs through it
• A clear path to the roof and the side yard
• The owner or manager reachable to approve the scope

When the 24/7 emergency line makes sense

Our 24/7 emergency line is for chimney problems that cannot wait for a regular visit. A section of masonry that has fallen or is about to, water pouring in around the chimney or a chimney struck by a falling limb all qualify.

Fire and smoke are a different matter. If there is a fire in the chimney or smoke filling the room, get everyone out and call 911 first. The fire department comes before any chimney company, and the chimney is looked at only once they say the house is safe.

When you reach the line, describe what happened, where it is on the house and whether anything is still coming down or coming in, so the visit to your Moss Park home can start at the right spot. In the meantime, keep everyone away from it and stay off the roof.