Skip to content

Proudly American | Family owned

Same-day service available

(352) 675-6376 Book Online

Family-owned chase cover service in Orwin Manor

Stop water at the top of your Orwin Manor chase with a sloped, collared cover. Book within 72 hours after your free inspection and take 10% off.

  • Licensed & insured
  • Locally run
  • Family owned and operated
  • Same-day service available
4.8 out of 5 from 736 reviews
  • Google
  • Yelp
  • Facebook

Your Orwin Manor chase top, item by item

  1. Fasteners matched to the cover metal
  2. Old cover, screws and sealant removed and hauled away
  3. 10% off any service booked within 72 hours
  4. Workmanship warranty on the installation

What goes into a new chase top in Orwin Manor

Leaves and needles on the chase top

Trees near the roof drop leaves, needles and seed pods that collect on a chase cover, especially one with little slope. The debris holds moisture against the metal and blocks the path water should take to the edges. A well-shaped cover sheds much of it on its own. If branches overhang the chase, trimming them back reduces both debris and a climbing route for animals, and we point out those limbs during the inspection. Pine needles tend to lodge in the creases of a cover, and a steeper pitch helps them wash off.

Chases finished with fiber cement or wood siding

Fiber cement and wood lap siding create a stepped outline at the top of the chase. The skirt has to reach below the high points of that profile, and corner trim boards often stand proud of the siding. We measure at the widest points so the cover laps over the finish on every side. Where wood trim at the top has softened, we record it before the new cover goes on, because fastening into soft trim does not hold.

A cover that sits inside the siding

Some leaks come from a cover that was simply made too small. Instead of lapping over the siding, the skirt sits inside it or stops short, and water enters at the joint. This happens when measurements were taken off the framing, or when the chase was re-sided after the cover went on. We compare the cover's size to the finished chase and, if it falls short, specify a new one to the outside dimensions. An undersized cover sometimes gets a strip of flashing added around it, which only adds more joints that can leak.

A local family team on your roof

Orlando Chimney Service is family owned and locally owned. We explain chase top findings in plain words, and the details measured on your roof are the details written into the order for the new cover. When you have a question after the job, you reach the same local business that did the work, which keeps the follow-up simple. Our chase cover pros would rather answer a question twice than leave you unsure what was installed. That also means the people who stand behind the workmanship warranty are the same local business you called.

Asked in Orwin Manor about chase cover replacement

What is the difference between a chase cover and a chimney cap?

The chase cover is the broad metal lid over the framed enclosure. The cap is the smaller hooded part on the chimney pipe. Either can rust, and we identify which one needs work before quoting.

Can a rusted chase cover be patched?

A small, isolated defect can sometimes be repaired. A cover rusted through in several places keeps failing around each patch, so we explain which option fits your cover after seeing it.

Request your free estimate

Share the job details and arrange a free inspection with our local team.

  • Free inspection
  • No hidden fees
  • Family owned and operated

Need an answer now? Call (352) 675-6376

Tell us what needs attention. We will contact you to arrange your free inspection.

Call(352) 675-6376