Honest chimney chase repair for Rose Isle homes
Leaking chase? We cover it, trace the water and give you a free written estimate before any permanent work.
- Licensed & insured
- Locally run
- Family owned and operated
- Same-day service available
Your chase repair scope, layer by layer
- Probe test of siding, corners and the chase base
- Siding removed and reused where boards are sound
- Rotted studs, plates and corners replaced or sistered
- Seam and flashing where the chase meets the house
Chase repair details that keep the wall dry
Front and back flashing that follows the shingle maker
The downslope face of a chase gets an apron flashing that lies over the shingles, and the upslope face gets a back flashing or a cricket. Under R905.2.8.4, chimney flashing on a shingle roof is applied following the asphalt shingle manufacturer's instructions.
So the details can change with the shingle brand, and a repair should follow the instructions for the roof you actually have. A bead of tar along the joint is not flashing. It usually hides a gap rather than closing it, and it can trap water against the siding.
We look at the apron and back flashing whenever the lower chase siding is off. Your estimate states whether that flashing is reused, replaced or left for a roofer, so nobody assumes someone else handled it. If the apron has been caulked or tarred over, the old material comes off so the flashing can be judged properly.
Changing the chase finish to suit the house
A chase repair is a chance to change the finish. Some homeowners swap rotted panel siding for fiber-cement lap, match the chase to a stucco house or trade vinyl for a painted finish. Each change brings its own barrier, flashing and fastening rules.
Going to stucco on a framed chase means the two-layer barrier, corrosion-resistant lath and three coats the code describes. Going to fiber-cement means protected joints and the maker's fastening. The framing underneath has to be flat and sound for either one. Moving from siding to stucco also adds weight and curing time, which the schedule has to allow for.
Our technicians price the like-for-like repair and the change side by side, so you can weigh them. For your Rose Isle home, we also check whether a new finish changes how the cover or the roof flashing meets the chase, and we list any follow-on work.
Firestops where the pipe passes a floor or ceiling
Where a factory-built chimney passes through a floor or ceiling, the chimney maker calls for a firestop, a metal plate that closes the framed opening while keeping the air space around the pipe. DuraVent's DuraChimney II instructions, for example, call for a firestop at every floor and ceiling level, including where the chimney enters the attic, but not at the roof.
The Florida Building Code, in R302.11, also calls for fireblocking in concealed spaces of wood-framed walls at ceiling and floor levels. Each plate is fastened to the framing as the maker shows, with the air space around the pipe left open.
Each firestop gets checked for position, fastening and damage whenever a chase is opened. Missing or damaged firestops are replaced with the chimney maker's listed part, and any that were missing are pointed out to you before the chase on your Rose Isle home is closed.
A home inspection note about the chase
Home inspection reports often flag a chase with notes like soft wood at the base, damaged siding, staining, missing flashing or a cover that needs attention. Those notes describe what the inspector saw from outside, not how far the damage goes.
If you are buying or selling, a clear repair scope helps everyone agree on what needs to be done and by whom. Sellers often want the repair done before listing, while buyers may want a firm price to negotiate with. Both need the same thing, a scope that names each layer and each item.
Our technicians inspect the chase against the report, probe the areas it names and give you a written estimate that answers each note. The cover, the chase repair and any roofing are listed separately, so buyers, sellers and agents can see what each item covers for a home in Rose Isle.
Other work in Rose Isle
-
-
-
-
Before you book chase repair in Rose Isle
Do I need a new cover on top when the chase is repaired?
Only if the cover has failed or no longer fits the repaired top. When it has, the cover goes on its own estimate line and is installed after the top framing is sound. If the cover is in good shape, we take it off carefully and put it back.
How do you price damage you cannot see yet?
The estimate prices what the inspection can confirm and explains how hidden damage is handled. If opening the chase shows more rot, we stop, show you and write up the added work with its price. Nothing extra is done until you approve it.
Request your free estimate
Share the job details and arrange a free inspection with our local team.
- Free inspection
- No hidden fees
- Family owned and operated
Need an answer now? Call (352) 675-6376
Your request is received
Thank you. We will contact you to discuss the job and confirm an appointment.