Skip to content

Proudly American | Family owned

Same-day service available

(352) 675-6376 Book Online

Sealed gas fireplace inserts installed by local pros in Sand Lake Hills

From an empty firebox to a working gas insert in Sand Lake Hills, planned step by step and backed by our workmanship warranty.

  • Licensed & insured
  • Locally run
  • Family owned and operated
  • Same-day service available
4.8 out of 5 from 736 reviews
  • Google
  • Yelp
  • Facebook

Your Sand Lake Hills fireplace, checked against the insert manual

Four checks from a typical gas insert visit in Sand Lake Hills. Your own estimate lists every item that applies to your fireplace.

  1. Rear width and side angles measured, beyond the face of the opening
  2. Outlet inside the firebox or a cord route to a nearby outlet
  3. Surround size, depth and overlap on the fireplace face
  4. Controls, remote and battery backup explained at handover

Fitting a gas insert to your Sand Lake Hills fireplace, explained

Written by the family-owned crew that fits gas inserts across Sand Lake Hills.

A clean firebox before the insert slides in

The preparation list in the Supreme manual starts inside the fireplace. The wood-burning cavity has to be clean and free of ash, soot and other debris before the insert is set. Whatever stays behind ends up trapped behind the surround, where nobody will reach it again without pulling the insert back out.

Our crew brushes and vacuums the firebox, the smoke shelf and the damper area as part of the prep. Floors and the hearth are covered while we work, and the room is left as clean as we found it.

What an insert is designed to heat

A gas insert warms the room it sits in. Heat & Glo states plainly that its Supreme inserts are not intended for use as a primary heat source, and that they are tested and approved as supplemental room heat or as a decorative appliance.

For many homes, that matches how the fireplace gets used on cool evenings. We help you pick a size that suits the room, and we will never suggest an insert can take the place of your home's heating system.

Choosing an insert size for the room

Inserts come in sizes, and the manual lists each one's maximum and minimum input in BTUs per hour. A bigger unit is not automatically a better one. In a small room or a tightly sealed house, a high input can make the space uncomfortably warm.

We weigh the floor area, the ceiling height, any wide openings into other rooms and how you use the fireplace, then suggest a size that fits your firebox and your comfort. The rating plate on the insert you choose is what we check against.

Room size and vented gas heaters

The code also ties some vented gas appliances to room volume. Section 304.5.1 of the Fuel Gas Code sets a standard method of fifty cubic feet of room volume for every 1,000 BTUs per hour of appliance input, and section 303.3 uses that test for vented gas fireplace heaters in bedrooms and bathrooms.

For a sealed direct-vent insert, the direct-vent exception usually governs. We still measure the room and check the input of the model you want, so the recommendation is backed by numbers.

Your gas insert questions, Sand Lake Hills edition

Not covered here? Our Sand Lake Hills team will answer on the phone.

Can I still burn wood after a gas insert is installed?

No. The converted fireplace is labeled for gas insert use only. Going back to wood means removing the insert and its liners and having the fireplace and chimney approved again.

Can a gas insert go in a bedroom fireplace?

Florida's Fuel Gas Code bars gas appliances from bedrooms, though a direct-vent unit installed to its listing is one of the allowed exceptions. Sealed inserts are generally direct vent, but your model's manual decides. We check before recommending one.

Request your free estimate

Share the job details and arrange a free inspection with our local team.

  • Free inspection
  • No hidden fees
  • Family owned and operated

Need an answer now? Call (352) 675-6376

Tell us what needs attention. We will contact you to arrange your free inspection.

Call(352) 675-6376