Chimney tuckpointing with matched mortar in Spring Lake
From the first chisel to the final brush, one family crew handles chimney tuckpointing in Spring Lake.
- Licensed & insured
- Locally run
- Family owned and operated
- Same-day service available
The joint plan our Spring Lake crew puts on paper
Our specialists check these points on the chimney in Spring Lake and list them in your proposal.
- Hand tools for head joints and soft brick
- Loose or spalled units priced separately
- Old hard patches and caulk removed
- Areas left alone and the reason
How our crew repoints a chimney in Spring Lake
Our masons explain these three parts of the job in Spring Lake before any joint is raked out.
Hard cement patches and chipped brick edges
Preservation Brief 2 explains that mortar stronger than the brick forces stresses to relieve through the brick itself. The telltale sign is chipped or broken brick edges around a hard, gray patch that is still perfectly intact.
If earlier repairs on your Spring Lake chimney used a very hard mix, our masons remove it with care to avoid more edge damage, and the new mortar is matched to the brick. Bricks already broken by the old patch are noted separately for replacement. The old patch area is often where our crew spends the most careful time on the whole chimney.
Finishing joints against worn brick edges
When old bricks have rounded, worn edges, filling the joint flush makes it look wider than it is and leaves a thin edge of mortar that breaks off easily. Preservation Brief 2 recommends recessing the final mortar slightly from the face in that case.
On older-looking brick on your Spring Lake chimney, our masons finish joints just behind the worn edges. The joints look the right width and the mortar holds its edge, which is better for appearance and for keeping water out. It is a detail most people never notice, which is the point.
A uniform depth across the joints
Technical Note 46 describes raking deteriorated mortar to a uniform depth. When some joints are raked deep and others barely touched, the new mortar varies in thickness from joint to joint, which makes an even bond and an even finish harder to achieve.
Our masons work each area of your Spring Lake chimney to a consistent depth, head joints as well as bed joints. It is slower than chasing only the worst spots, and it is what gives the new joints an even bond and an even look. An even depth also makes the finished joints look consistent from the street.
Other work in Spring Lake
-
-
-
-
What Spring Lake homeowners ask about chimney mortar
Deciding on joint work? The inspection in Spring Lake is free.
Do hairline cracks need full repointing?
Not always. Fine cracks in otherwise sound mortar can sometimes be handled with face grouting, while cracks through the joint call for repointing. We check which applies on your Spring Lake chimney.
Do you offer a discount on tuckpointing?
Book within 72 hours after your free inspection and take 10% off, and chimney tuckpointing qualifies. The discount shows on your written estimate before you approve the work.
Request your free estimate
Share the job details and arrange a free inspection with our local team.
- Free inspection
- No hidden fees
- Family owned and operated
Need an answer now? Call (352) 675-6376
Your request is received
Thank you. We will contact you to discuss the job and confirm an appointment.