Natural and cultured stone chimney repair in Eagle Creek
Stone chimney work in Eagle Creek done carefully by a locally owned crew, and if it is not right, we return and fix it.
- Licensed & insured
- Locally run
- Family owned and operated
- Same-day service available
Line by line on your stone chimney in Eagle Creek
Just had your free inspection in Eagle Creek? The written lines show 10% off as well when you book within 72 hours.
- Cleaning timed after the mortar hardens
- Cap, crown and flashing work listed separately
- Flue and liner work listed separately
- Permit requirement checked for rebuild work
How we repair stone chimneys in Eagle Creek
Short reads that help before you approve stone work in Eagle Creek.
Full mortar coverage behind each stone
The same instructions require a setting bed with complete coverage of the back of each unit and full contact between mortar, stone and backing. Stones are back-buttered to fill their textured backs, then pressed into a half inch to three quarters of an inch of mortar until it squeezes out around the whole edge.
Stones set with a few dabs of mortar leave voids behind them. Those voids hold water and let stones pop off. When we reset veneer, every stone goes back with full coverage.
Preparing joints before filling
Preservation guidance wants the old mortar cut out cleanly to a flat, squared back, and the joint washed free of dust and loose grit. At the time of filling, joints should be damp with no standing water.
Dust and a rounded back are what let new mortar pop out later. Our crew cleans each joint to a square, sound back and dampens it just before filling, section by section.
Acid cleaners and stone
Preservation guidance keeps chemical cleaners, acids above all, off dry masonry, and has the wall wetted thoroughly before any chemical and rinsed well after it. One manufactured stone maker rules out acid and acid-based products entirely.
Acid can etch some natural stones and discolor cast stone. We start with water and mild detergent, test anything stronger on a hidden spot and tell you in writing what was used and why.
Flue and liner work kept separate
Stone on the outside does not change the flue inside, and the flue or its liner can need attention for reasons that have nothing to do with the stone outside. Those findings belong in the report but not in the stone line.
When we see something in the flue during a stone job, we describe it, explain whether it needs attention soon and give it its own line. Stone work can go ahead on its own when the flue is sound enough to use.
Cutting stone safely around your home
Cutting and grinding stone raises fine dust. One maker's instructions caution that dust from cutting its product contains crystalline silica and call for eye protection and a properly fitted respirator when cutting.
We cut outdoors, away from open windows and doors, with wet cutting or dust collection where practical, and keep children and pets well away from the cutting area. Dust is cleaned from walkways and surfaces before we leave.
Other work in Eagle Creek
-
-
-
-
Stone chimney questions from Eagle Creek
Short answers from the crew that repoints stone in Eagle Creek. Call with anything else.
Can you replace just the loose stones on my chimney?
Often, yes. When the backing and the surrounding stones are sound, we remove the loose pieces, clean them and reset them in a full bed of fresh mortar. We check why they came loose first, because a stone reset over the same problem will loosen again.
Why do you use a softer mortar on stone?
Repointing mortar should be softer and more vapor permeable than the stone around it, so moisture leaves through the joints and any stress is taken by mortar that can be replaced. Mortar that outlasts the stone in hardness tends to push the damage into the stone faces instead.
Request your free estimate
Share the job details and arrange a free inspection with our local team.
- Free inspection
- No hidden fees
- Family owned and operated
Need an answer now? Call (352) 675-6376
Your request is received
Thank you. We will contact you to discuss the job and confirm an appointment.