Chase cover replacement by local pros in Hibiscus
Rust streaks, a sagging top or water in the fireplace? Our Hibiscus chase cover specialists find the cause and quote the fix in writing.
- Licensed & insured
- Locally run
- Family owned and operated
- Same-day service available
What your Hibiscus chase cover estimate covers
- Pipe position and outside diameter recorded
- Cross-breaks or a pitched top that drains to the edges
- Storm collar refitted or replaced
- Top of the framing checked while the cover is off
Getting the chase top right in Hibiscus
Keeping the listed termination cap in service
Factory-built chimneys are tested and listed as systems under UL 103, and the Florida residential code requires them to be installed and terminated according to the manufacturer's instructions. The cap on top belongs to that system. When the cap is sound, we lift it off carefully, replace the cover beneath and reinstall the same cap. When it is damaged, the replacement should be the cap approved for that chimney model, since a cap chosen for looks can change how the system was listed to perform.
Chases finished with fiber cement or wood siding
Fiber cement and wood lap siding create a stepped outline at the top of the chase. The skirt has to reach below the high points of that profile, and corner trim boards often stand proud of the siding. We measure at the widest points so the cover laps over the finish on every side. Where wood trim at the top has softened, we record it before the new cover goes on, because fastening into soft trim does not hold.
Split seams on older covers
Covers made from more than one piece of metal rely on seams, and seams are where sealant ages first. A split seam can let water drip straight into the chase even when the rest of the sheet looks fine, and collar seams deserve an equally close look. We inspect every seam and, on a replacement, favor one-piece construction or properly formed and sealed seams so there are fewer joints to fail. Seams on the old cover also show where the previous installer ran short of metal, which tells us how it was built.
Backed by our satisfaction guarantee
Every chase cover we install comes with our workmanship warranty and our 100% satisfaction guarantee. Should the finished work fall short, tell us and our crew comes back to set it right. Book within 72 hours after the free inspection and 10% comes off, written into the estimate before you approve it. The inspection that comes first is free, so you see the full scope before deciding anything. The satisfaction guarantee covers the work we do on your chase, from the measurements to the finished water test.
Other work in Hibiscus
-
-
-
-
-
-
Learn more about chimney chase cover replacementHibiscus services
Related chase cover work
Chase top answers for Hibiscus homeowners
How long does chase cover replacement take?
It usually takes two visits. We measure at the free inspection, the cover is fabricated to those measurements, and installation follows once it is ready. You get a timeline when you approve the work.
Why is my new cover sloped instead of flat?
A flat sheet sags and holds rain, which wears the metal out from the middle. Creases or a pitch send water to the edges, and the fireplace manuals we follow call for the top to slope away from the pipe.
Request your free estimate
Share the job details and arrange a free inspection with our local team.
- Free inspection
- No hidden fees
- Family owned and operated
Need an answer now? Call (352) 675-6376
Your request is received
Thank you. We will contact you to discuss the job and confirm an appointment.