Skip to content

Proudly American | Family owned

Same-day service available

(352) 675-6376 Book Online

Chase cover replacement by local pros in Lorna Doone

We check what is under the old chase cover in Lorna Doone and tell you before any added repair. No hidden fees.

  • Licensed & insured
  • Locally run
  • Family owned and operated
  • Same-day service available
4.8 out of 5 from 736 reviews
  • Google
  • Yelp
  • Facebook

What your Lorna Doone chase cover estimate covers

  1. Chase measured over the finished siding on all four sides
  2. Pipe position and outside diameter recorded
  3. Hemmed drip edge on every side
  4. Water test on the finished top where footing allows

Getting the chase top right in Lorna Doone

Measuring over the finished siding

The size that matters is the outside of the chase at the top, taken over the siding, stucco or trim. Framing dimensions are smaller by the thickness of every layer added later. A cover built to framing size sits inside the finish rather than lapping over it, and water runs into the joint. We measure each side at the top of your Lorna Doone chase, note where trim boards stand proud and size the skirt to clear the thickest point with room to fasten.

What we check while the top is open

The time the cover is off gives the only full view of the chase top, so we use it. Findings are recorded in writing, and anything outside the cover replacement is priced as its own item for you to approve or decline.

  • The outer casing of the chimney pipe, for rust or damage
  • The joints where pipe sections lock together
  • The edges of the framing and sheathing at the top
  • Debris, nests or wet insulation inside the enclosure

Scheduling the inspection and the installation

Chase cover work usually takes two visits. The first is the free inspection, where we measure, look at everything we can reach and write the estimate. The second is installation, after the cover has been fabricated to those measurements. Same-day service is available for many inspections in Lorna Doone, and we give you an expected fabrication window when you approve the work. If the old cover is leaking badly in the meantime, we talk through temporary protection. If you are comparing quotes, the free inspection gives you a written scope you can hold other proposals against.

A local family team on your roof

Orlando Chimney Service is family owned and locally owned. We explain chase top findings in plain words, and the details measured on your roof are the details written into the order for the new cover. When you have a question after the job, you reach the same local business that did the work, which keeps the follow-up simple. Our chase cover pros would rather answer a question twice than leave you unsure what was installed. That also means the people who stand behind the workmanship warranty are the same local business you called.

Your Lorna Doone chase cover questions, answered

How long does chase cover replacement take?

It usually takes two visits. We measure at the free inspection, the cover is fabricated to those measurements, and installation follows once it is ready. You get a timeline when you approve the work.

Why is my new cover sloped instead of flat?

A flat sheet sags and holds rain, which wears the metal out from the middle. Creases or a pitch send water to the edges, and the fireplace manuals we follow call for the top to slope away from the pipe.

Request your free estimate

Share the job details and arrange a free inspection with our local team.

  • Free inspection
  • No hidden fees
  • Family owned and operated

Need an answer now? Call (352) 675-6376

Tell us what needs attention. We will contact you to arrange your free inspection.

Call(352) 675-6376