Direct vent gas insert installation for Zellwood
Gas insert installation in Zellwood with the opening measured, the liners run and the surround fitted clean. 100% satisfaction guaranteed.
- Licensed & insured
- Locally run
- Family owned and operated
- Same-day service available
What goes on paper before a gas insert is installed in Zellwood
No product photo can tell us these things. We check them at your fireplace in Zellwood and list them with upfront pricing.
- Chimney passageway examined and cleaned before connection
- Vertical vent height checked against the insert's minimum and maximum
- Controls, remote and battery backup explained at handover
- Workmanship warranty and the 72-hour 10% discount shown on the estimate
What a gas insert job involves in Zellwood
A few of the things our installers walk Zellwood homeowners through before an insert goes in.
Why the chimney is examined before hookup
Florida's Fuel Gas Code has a rule for exactly this job. Section 503.5.6 says that before an appliance is connected to a chimney, the passageway must be examined to confirm it is clear and free of obstructions, and cleaned if it previously vented a fireplace or another solid- or liquid-fuel appliance.
A chimney that carried wood smoke for years will almost always need that cleaning. We do it as part of the preparation, or list it on the estimate when it is a bigger job, before the insert's liners go down. A new gas appliance never gets connected to a passage that has not been cleaned and checked.
A surround that closes the gap
The surround is what you see around the insert, and it also closes the opening between the insert and the fireplace face. The Supreme manual says to push the insert in until the surround tightly overlaps the fireplace opening, and allows only an approved surround to cover the built-in grilles of a wood-burning fireplace.
It rules out shrouds, sheet metal plates or other parts used to seal off those vents. We fit the surround the maker supplies for your model and adjust the leveling legs until it sits tight against the face all the way around.
Swapping a wood insert for a gas one
Some fireplaces already hold a wood-burning insert. Replacing it with gas means taking out the wood insert and its chimney liner, then installing the gas insert with its own listed vent system.
They are different appliances with different vents, and the old wood liner cannot stand in for the gas insert's direct-vent liners. We clean and check the chimney once the wood insert is out, before the gas insert goes in.
How install day runs
Install day follows a set order: protect the room, remove the old doors and grate, clean and prepare the firebox, set the damper, run and connect the liners, fit the cap, make the gas and electrical connections, set the insert, fit the surround and start it up.
Our crew keeps to that order because each step depends on the one before it. You get a short walkthrough at the end and a clean room.
Other work in Zellwood
-
-
-
-
-
-
Learn more about gas fireplace insert installationZellwood services
Quick gas insert answers for Zellwood
Short, straight answers from our fireplace team in Zellwood. Anything else, just call.
Can a gas insert go in a bedroom fireplace?
Florida's Fuel Gas Code bars gas appliances from bedrooms, though a direct-vent unit installed to its listing is one of the allowed exceptions. Sealed inserts are generally direct vent, but your model's manual decides. We check before recommending one.
Do I have to remove my mantel for an insert?
Not if it meets the insert's clearance table. We measure its height and depth against the table for your model. If it falls short, we explain the choices before anything is ordered.
Request your free estimate
Share the job details and arrange a free inspection with our local team.
- Free inspection
- No hidden fees
- Family owned and operated
Need an answer now? Call (352) 675-6376
Your request is received
Thank you. We will contact you to discuss the job and confirm an appointment.